4229 installation manual

the installation instructions for that control unit. Set the DIP switch to one of 16 addresses, as shown in the table below, so the control can identify the module and communicate with it properly. The address to be set is determined by the particular control to be used, and the control’s installation instructions must be consulted. As. • Install a smoke detector inside bedrooms where electrical appliances (such as portable heaters, air conditioners or humidifiers) are used. • Install a smoke detector at both ends of a hallway if the hallway is more than 40 feet (12 meters) long. • Install smoke detectors in any room where an alarm control is located, or in any room. ASSEMBLING INSTALLATION INSTRUCTIONS PRODUCT# WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. Fig.1 ASSEMBLING THE FIXTURE (Fig.2). 1. Return the arms to suitable position. 2. Attach the loop (A) to the fixture body (B) by turning it clockwise until tight. 3. Raise the pipe nipple (E) into the bottom coupling of fixture body(B).

Figure 1: Installation flow chart. Install BUC system as per mounting instructions. Earth the equipment. Seal all cable connections. Align the antenna to the main lobe of the satellite and set the polarisation angle in accordance with manufacturer's instructions and satellite provider. Tighten all fasteners and brackets. Secure cables with. Wired zone expander / relay board. Provides 8 end-of-line supervised zones and 2 on-board programmable form C relays. Connection made to the control's console wires. Supported on VISTAHW. Documents. Ordering Info. Part No. Description. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS 1 General Safety Information This manual contains important instructions for the Delta's Smart Rapid Shutdown System that should be followed during installation and maintenance. To prevent the risk of electrical shock, and to ensure long-term operation, read these instructions.

Save this manual to your list of manuals Honeywell manual content summary: N 9/97 Rev. B ADEMCO WIRED ZONE EXPANDER/RELAY MODULE INSTALLATION AND SETUP GUIDE GENERAL INFORMATION The ADEMCO Wired Zone Expander/Relay Module adds up to eight end-of-line resistor supervised zones and two dry form C (SPDT) relay outputs to compatible control communicators via. Wired Zone Expander/Relay Module – Installation Instructions GENERAL INFORMATION The ADEMCO Wired Zone Expander/Relay Module adds up to eight normally closed or eight end-of-line resistor supervised zones and two dry form C (SPDT) relay outputs to compatible control communicators via the control’s keypad wiring. ASSEMBLING INSTALLATION INSTRUCTIONS PRODUCT# WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. Fig.1 ASSEMBLING THE FIXTURE (Fig.2). 1. Return the arms to suitable position. 2. Attach the loop (A) to the fixture body (B) by turning it clockwise until tight. 3. Raise the pipe nipple (E) into the bottom coupling of fixture body(B).